Replacing The Fuse; Technical Specifications - EuroLite LED SLS-503 TCL User Manual

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX control channels:
DMX512 connection:
Sound control:
Flash rate:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Fuse:
Number of LEDs:
LED type:
Beam angle:
Dimensions (WxDxH):
Weight:
Accessories:
IR-4 Remote Control
IEC extension 3x1.0 1m
TH-50S Theatre clamp bk
Safety bond 3x600 black
DMX cable XLR 3pin 3m bk
SB-18 Soft bag
DMX LED Operator 1 controller
DMX LED Operator 4 controller
Control Panel
Mic
MODE UP DOWN ENTER
Please note: All information is subject to change without prior notice. 25.07.2014 ©
110-240 V AC, 50/60 Hz ~
20 W
3/5
3-pin XLR
via built-in microphone
0 - 10 Hz
: 45° C
a
(steady state): 60° C
C
0.5 m
0.1 m
T 0.5 A, 250V
5
3 W TCL
17.5°
235 x 110 x 210 mm
1 kg
No.
51915279
30235200
58000651
58010252
30307457
30130555
70064501
70064504
23/23 00083282, Version 1.0