Installing Hard Disks - Asus DELUXE P5LD2 User Manual

Asus computer hardware user manual
Hide thumbs Also See for DELUXE P5LD2:
Table of Contents

Advertisement

I n t e l
I n t e l
M a t r i x S t o r a g e
M a t r i x S t o r a g e
I n t e l
I n t e l
I n t e l
®
M a t r i x S t o r a g e
M a t r i x S t o r a g e. The Intel
M a t r i x S t o r a g e
by the ICH7R chip allows you to create a RAID 0 and a RAID 1 set using
only two identical hard disk drives. The Intel
creates two partitions on each hard disk drive to create a virtual RAID 0
and RAID 1 sets. This technology also allows you to change the hard disk
drive partition size without losing any data.
If you want to boot the system from a hard disk drive included in a
created RAID set, copy first the RAID driver from the support CD to a
floppy disk before you install an operating system to the selected hard
disk drive. Refer to section "5.6 Creating a RAID driver disk" for details.
5.5.1
5.5.1
5.5.1

Installing hard disks

Installing hard disks
Installing hard disks
5.5.1
5.5.1
Installing hard disks
Installing hard disks
The motherboard supports Ultra DMA /133/100/66 and Serial ATA hard
disk drives. For optimal performance, install identical drives of the same
model and capacity when creating a disk array.
Installing Parallel ATA hard disks
Installing Parallel ATA hard disks
Installing Parallel ATA hard disks
Installing Parallel ATA hard disks
Installing Parallel ATA hard disks
To install IDE hard disks for a RAID configuration:
1.
Set the jumpers of each hard disk as Master/Master or Slave/Slave.
2.
Install the hard disks into the drive bays.
3.
Connect the HDD signal cables.
4.
Connect a 4-pin power cable to the power connector on each drive.
Installing Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks
To install the SATA hard disks for a RAID configuration:
1.
Install the SATA hard disks into the drive bays.
2.
Connect the SATA signal cables.
3.
Connect a SATA power cable to the power connector on each drive.
Refer to the RAID controllers user manual on the support CD for detailed
information on RAID configurations.
5 - 1 8
5 - 1 8
5 - 1 8
5 - 1 8
5 - 1 8
®
Matrix Storage technology supported
®
Matrix Storage technology
C h a p t e r 5 : S o f t w a r e s u p p o r t
C h a p t e r 5 : S o f t w a r e s u p p o r t
C h a p t e r 5 : S o f t w a r e s u p p o r t
C h a p t e r 5 : S o f t w a r e s u p p o r t
C h a p t e r 5 : S o f t w a r e s u p p o r t

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents