Table of Contents
Advertisement
To avoid electrical shock which can cause severe personal injury or death, do not remove outer case at any time.
Only an authorized servicer should remove outer case.
An authorized servicer MUST inspect equipment annually.
Record all inspections and repair for future reference.
Problem
Oven does not operate.
Oven operates intermittently.
If oven does not accept entries
when pad is pressed.
If oven malfunctions or shows
ERR
with a number:
Oven operates but does not heat
food.
HOT
displays
Part No. 12861701
Printed in U.S.A. 12/04
Before Calling for Service
!
WARNING
Possible Cause
Confirm oven is plugged into dedicated circuit.
Confirm oven is on grounded and polarized circuit.
(Contact electrician to confirm)
Check fuse or circuit breaker.
Check air filter and discharge areas for obstructions.
Make sure oven is on.
Open and close oven door. Press pad again.
Oven control is equipped with a self-diagnostic system. Self-diagnostic
system alerts you if there is a error or problem. When electronic control
signals a problem, follow steps listed below.
1. Record number shown.
2. Unplug oven, wait for 1 minute, and plug in oven.
• Disconnecting electrical supply may eliminate service code. If failure
continues, contact an authorized Amana servicer.
Place one cup of water in oven.
Run for one minute at full power (100%).
If temperature does not rise, oven is not operating correctly. Contact
authorized Amana servicer.
Oven's magnetron is overheated. Oven automatically interrupts cooking
sequence and turns on cooling fan until normal temperature is reached.
When magnetron cools to normal temperature, oven returns to READY
mode.
F
or full product documentation visit:
www.amanacommercial.com/wavelink
™
2004 Amana Appliances
Amana, Iowa 52204
Advertisement
Table of Contents
