Usb Operation; Programmed Playback - LENCO SCD-38USB Instruction Manual

Note on CD-R/RW discs
- Because of non-standardized format definition/ production of CD-R/RW, playback quality and performance are not
guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
writing software, media ability, etc.
- Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
- It is recommended to record only audio files on CD-R/RW discs for easy reading.
FOLDER UP
For MP3/WMA/USB playback, when the unit is at STOP mode, skip up to next
folder/album at increasing order, press PLAY/PAUSE button to start the
playback of the selected folder/album.
When the unit is at MP3/WMA/USB PLAYBACK mode, skip up to next folder/album
at increasing order, then it will start playback of the selected folder/album.

USB OPERATION

1. Set to USB.
2. Connect USB disk or MP3 player into the USB port.
3. Press the STOP / CD / USB button and display will show total track & "USB".
4. Press the PLAY/PAUSE
note: USB connector does not support connection with USB extension cable and
it is not designed for communication with computer directly.
Manufacturer is not responsible for the playability of USB disk or MP3 player
due to recording condition, capacity, interface compatibility, etc.
Due to different formats, some USB disks or MP3 players may take longer
time to be read.
USB stick is direct connected or with a cable with max. 0,5 m length.
Unit will be automatically off within 15 mins without further operation (in stop mode).
After auto off, slide the FUNCTION selector to OFF position and then slide to USB position for listening.

PROGRAMMED PLAYBACK

PROGRAMMED PLAYBACK
FOR NORMAL COMPACT DISC PLAYBACK
Programmed playback enables tracks on a disc to be played in
the desired order. Up to 20 tracks can be programmed.
1. Press the " PROGRAM " button.
2. Press the " NEXT " and " PREV
to select the desired track number.
3. Press " PROGRAM " button again to memorize the
track.
4. Repeat steps 2 and 3 until all desired tracks are
programmed.
5. Press the " PLAY/PAUSE
" " & " PROG. " are shown on the CD display.
button to start playback.
" buttons
" button to start.
GB 4
FUNCTION
USB
6. Press the " STOP " button once to stop
programmed playback.
7. Press the " PLAY/PAUSE
programmed playback.
8. Open the CD door or turn off the CD player or press
" STOP " button twice to clear the programmed
memory.
Note : Programming can only be made when the player
is in stop mode.
CD display
" PROGRAM "
USB display
" buttons to resume