dixell XWEB 3000 Operating Instructions Manual page 14

XWEB 3000 – rel.1.0 –
Connect the USB Modem to the USB Port on the back side using the modem cable commonly
included into the modem packaging itself.
There is no need to give power supply to the modem because the Server provides it through the USB
port.
The modem reset is directly controlled by the XWEB 3000 Server through the USB port by turning off
and then on the modem device.
Connect the modem to the telephone line with the phone cable included into the modem packaging.
Remember to check if there is a switching machine.
The connection procedure is divided in two parts:
In the first part it is necessary to create the Remote Access, in your remote PC, set with the telephone
number of the line where the XWEB 3000 is connected to. You have to use Dixell as Username and
Password.
The second is the procedure you will ever use: after launching the new Remote Access that will
engage the line through the modem, start the Browser from your PC and insert the address
http://192.168.1.200 into Explorer/Netscape address bar.
14