Table of Contents
Advertisement
Installation Instructions
STEP 1 : CABINET OR WALL OPENING
Provide an opening in the wall or cabinet, as indicated in SKETCH 1.
The depth should be a minimum of 15-3/4". The floor of the opening should be constructed of
plywood strong and thick enough to support the weight of the oven <about 50 lbs.> and installa-
tion job.
First, punch the 4-holes using the template, Place the Duct-Rail on the Bottom of the Cabinet.
Coincide the Duct-Rail holes with the bottom holes of the Cabinet.
Screw the Duct-Rail using Screw B(4EA)
NOTE :
While the proper functioning of the oven does not require that opening be enclosed (with sides,
ceiling and rear partition) this may be required by local code, and it is suggested that the local
code be checked for any such requirement.
W
H
D
STEP 2 : TRIM ASSEMBLY
Position the ASSY TRIM and SIDES as shown in SKETCH 2.
Make sure that the ASSY TRIM and SIDES are lined up properly to be neat and symmetrical.
Then using Screw B(4EA) , screw the parts together at screw locations shown in SKETCH 2.
©2004 Maytag Services
W
16022923 Rev. 0
D
H
SKETCH 1
SKETCH 2
A – 3
Advertisement
Table of Contents
