C) Using The Different Functions - Brandt TI2FSOFT Instruction Manual

If you place an incompatible container on the ceramic plates, the LED display will show "E1"
and the induction cooker will beep and switch off automatically after 30 seconds.

c) Using the different functions

 Simmer mode
To use this mode, press on the Simmer button (2). A lamp lights up. The simmer cooker
entering the simmer state, the default power level shall be level 2. Under this mode, the
power cannot be adjusted. Pressing +/- buttons disable simmer mode.
 Fry mode
To use this mode, press on the Fry button (4). A lamp lights up. The default power level
shall be level 6. Pressing +/- buttons disable fry mode.
 Boil mode
Boil mode is for boiling water. To use it, press on the Boil button (5). A lamp lights up. The
default power level shall be level 10. After about 7 minutes, it will turn to 8 level powers. In
this mode, the default working time is 15 minutes. Pressing +/- buttons disable boil mode.
Note: It is recommended to put water that occupies 30% to 80% of the pot capacity when
boiling water.
 Boost mode
The boost button (6) allows you to go directly to the highest power level: 10 and then
maintain the maximum power without creating overheating of the device or cooking utensils.
A lamp lights up. Pressing +/- buttons disable boost mode.
 Keep warm mode
When the appliance is in operation, press on the Keep warm button (1) if you want to keep
warm your preparation. A lamp lights up. The appliance will set automatically on the lowest
power 1 and will stop after 120 minutes. To set again the power, press directly on the +/-
buttons.
 Timer
To use the timer, you just need to select a cooking mode and then press the timer button
(3). A lamp lights up. The digital screen will indicate « 00:00 ». During the following 4
seconds, press on the +/- buttons to adjust the cooking time. Each pressure increases or
decreases the time by 1 minute. If you maintain the button longer, the time will increase or
decrease by increments of 10 minutes. The timer can be set from 1 minute to 180 minutes.
26