Set Up The Hp Photosmart For Faxing; Countries/Regions With A Parallel-Type Phone System - HP C410 series User Manual

Chapter 3

Set up the HP Photosmart for faxing

Before you begin setting up the HP Photosmart for faxing, determine which kind of phone
system your country/region uses. The instructions for setting up the HP Photosmart for
faxing differ depending on whether you have a serial- or parallel-type phone system.
• If you do not see your country/region listed in the table below, you probably have a
serial-type phone system. In a serial-type phone system, the connector type on your
shared telephone equipment (modems, phones, and answering machines) does not
allow a physical connection to the "2-EXT" port on the HP Photosmart. Instead, all
equipment must be connected at the telephone wall jack.
NOTE:
cord that came with the HP Photosmart might have an additional wall plug
attached to it. This enables you to connect other telecom devices to the wall jack
where you plug in the HP Photosmart.
• If your country/region is listed in the table below, you probably have a parallel-type
telephone system. In a parallel-type phone system, you are able to connect shared
telephone equipment to the phone line by using the "2-EXT" port on the back of the
HP Photosmart.
NOTE:
2-wire phone cord supplied with the HP Photosmart to connect the HP Photosmart
to the telephone wall jack.
Table 3-1 Countries/regions with a parallel-type phone system
Argentina
Canada
Colombia
Indonesia
Korea
Mexico
Portugal
Singapore
Thailand
Vietnam
16 Finish setting up the HP Photosmart
Downloaded from ManualsPrinter.com Manuals
In some countries/regions that use serial-type phone systems, the phone
If you have a parallel-type phone system, HP recommends you use the
Australia
Chile
Greece
Ireland
Latin America
Philippines
Russia
Spain
USA
Brazil
China
India
Japan
Malaysia
Poland
Saudi Arabia
Taiwan
Venezuela