Table of Contents
Advertisement
RCU1010RF_US_QS_revA
9/12/03
Programming the Remote
The RCU1010RF remote can control up to nine components. In order for the remote to control your
components (TV, VCR, PVR/DVR, DVD, etc.), you must program it with the corresponding code entry from
the Code Lists. If your TV, VCR, DVD, or satellite receiver is an RCA, PROSCAN or GE brand, the RCU1010RF
may not need any programming to control it.
To program the codes for your components, you can use one of three methods: Code List Entry, Code Search
or Code Autosearch.
Use the Code List Entry method first, as this is the quickest and easiest
method. The Code Search method may require up to 300 keypresses, and the Code Autosearch
may take some time to cycle through all available codes.
During all code entries, the remote control unit must be pointing at the component you are programming.
While programming your remote, you may wish to extend the LCD touchscreen display time. Instructions
for this adjustment are below, followed by the three programming options.
Set the LCD Touchscreen Display Time
You can choose the length of time (10, 20, 30...90 seconds) that the touchscreen remains on after the last keypress.
The power-on default is 10 seconds from the last keypress, after which the unit automatically turns off. To adjust
this duration in 10-second increments up to 90 seconds, follow these steps:
1. Press and hold the SETUP key until the touchscreen shows
the Code Setup Mode? Screen. Release the SETUP key.
2. Press and release the SETUP key repeatedly until the
Set More Options? Screen appears.
3. Press and release the LCD OK key. The Set Time?
Screen now appears in the LCD.
4. Press and release the SETUP key repeatedly until the
Set LCD On Time? Screen appears. Press and release the
LCD OK key.
5. The LCD displays the LCD On for 10 Secs Screen (or the
length of time previously programmed). Press and release
the LCD UP or DOWN ARROW keys to select the desired
On Time. You can only change the time in 10-second
increments from 10 to 90 seconds. Press and release the
LCD OK key twice to confirm and save your settings.
6. The Set More Options? Screen is displayed. The Touchscreen
Display Time setting is now complete. To exit the Setup
Mode, press and release the EXIT key, followed by the
LCD OK key on the Exit Setup Screen.
Note: The 10-second display time will maximize battery life.
After the setup process is complete, you may want to reset
the display time back to 10 seconds..
Program the Remote Control Using Code List Entry
This is the quickest and easiest programming method. See User's Guide for Code Lists.
1. Manually turn on the component to be controlled
(TV, VCR, DVD, PVR/DVR, etc.).
2. Press and hold the SETUP key until the touchscreen shows
the Code Setup Mode? Screen. Release the SETUP key.
3. Press and release the desired component key (TV, VCR, SAT,
etc.) on the touchscreen. For AUX, press and release the
LCD AUX key followed by the desired component key to
be programmed.
Note: The AUX key automatically defaults to Cable
Mode unless another selection is made.
4. Enter the three-digit code for your component brand
from the corresponding Code Lists at the back of the
User's Guide. If your brand has more than one code listed,
begin with the first code. When a valid code from the list
is entered, the LCD displays the Code Save Success Screen,
followed by the Code Setup Mode? Screen.
16:01
Page 3
OR
Advertisement
Table of Contents
