Download
Share
Print this page
ACME LED-707 User Manual
  1. Manuals
  2. Brands
  3. ACME Manuals
  4. Spotlight
  5. LED-707
  6. User manual

ACME LED-707 User Manual

Hide thumbs

Advertisement

Quick Links

LED-707
User Manual
Please read the instructions carefully before use

Advertisement

loading
Need help?

Need help?

Do you have a question about the LED-707 and is the answer not in the manual?

Questions and answers

Related Manuals for ACME LED-707

Summary of Contents for ACME LED-707

  • Page 1 LED-707 User Manual Please read the instructions carefully before use...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS 1. Safety Instructions 2. Technical Specifications 3. Installation 4. How to control the fixture 5. DMX512 Configuration 6. DMX512 Connections 7. Troubleshooting 8. Fixture Cleaning...
  • Page 3 1. Safety Introductions Please read the instructions carefully which includes important information about the installation, operation and maintenance. WARNING  Please keep this User Manual for future consultation. If you sell the fixture to another user, be sure that they also receive this instruction booklet. ...

  • Page 4: Technical Specifications

    2. Technical Specifications Power supply Input Voltage： AC 100V-240V 50-60Hz 4 Channels Channel 1 = Mode Channel 2 = Pattern/Chase Channel 3 = Pattern Strobe/Chase Speed Channel 4 = Dimmer  It can be operated by DMX512 control or can be used as an individual unit without controller.

  • Page 5: How To Control The Fixture

    4. How to control the fixture Three ways to operation: A. Master/Slave operation B. Universal DMX controller C. Easy controller CA-8 A. Master/Slave operation The unit can be linked together in daisy chain as many as you need in master/slave mode to perform the great built-in pre-programmed lighting shows triggered by music.
  • Page 6 B. Universal DMX controller When using a universal DMX controller to control the chain of units, you have to set DMX address by Dip switches from 1 to 9 to make sure all the units will receive its DMX signal. Please refer to the following diagram to know how to address your DMX 512 system in the binary code.
  • Page 7 by, Function and Mode functions. Blackout Blackout the unit Function 1. Synchronous Strobe Chase Select 2. Sound Strobe (Chase 1-10) 3. Two light Strobe Sound/Strobe Mode Chase (LED OFF) (LED ON) DMX512 Configuration...

  • Page 8: Dmx512 Connections

    6. DMX512 Connections The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. Connect the fixture together in a “daisy chain” by XLR plug cable from the output of the fixture to the input of the next fixture. The cable cannot be branched or split to a “Y” cable.

  • Page 9: Troubleshooting

    errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture. Each lighting fixture needs to have an address set to receive the data sent by the controller.

  • Page 10: Fixture Cleaning

    1. Make sure the fixture does not receive DMX signal. 2. Check microphone to see if it is good by tapping the microphone. E. One of the channels is not working well 1. The stepper motor might be damaged or the cable connected to the PCB is broken. 2.
  • Page 11 Innovation, Quality, Performance...