Frigidaire ATF705X User Manual page 16

Installation
Water inlet
Do not use the hose from your previous appliance to connect to
the water supply.
WARNING!
Do not place the inlet hose down-
wards. Angle the hose to the left
or right depending on the position
of your water tap.
1. Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring nut
again to prevent water leaks.
Water drainage
The end of the drain hose can be positioned in three ways:
16
2. Connect the hose to a tap with
a 3/4" thread. Always use the
hose supplied with the ap-
pliance. The inlet hose must
not be lengthened. If it is too
short and you do not wish to
move the tap, you will have to
purchase a new, longer hose
specially designed for this type
of use.
Hooked over the edge of a sink us-
ing the plastic hose guide supplied
with the appliance. In this case,
make sure the end cannot come
unhooked when the machine is
emptying. This could be done by
tying it to the tap with a piece of
string or attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap
so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less than 60 cm
and not more than 90 cm. The end of the drain hose must
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of
the drain hose.
The drain hose must not be kinked.