Page 1
Ful! Size Tumble Action Washers Before beginning installation, carefully read these instructions. This will simpfify installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must...
Page 2
absence of local codes, with the National Electrical PRE-INSTALLAT!ON REQUIREMENTS Codes, ANSI/NFPA 70 (latest edition). If in doubt, call a licensed electrician. DO NOTcut off or alter Tools Required for Installation: the grounding prong on the power supply cord. In Phillips screwdriver situations where a two-slot receptacle is present, 10 mm socketwith...
Page 3
ROUGH-iN DiMENSiONS 23¾" 24" (60.33) (60.96) ID I 22" 25/8" (55.88) 35/8" (6.67) (9.21) 255/8" (65.09) 281/4" inches(cm) (71.76) NOTE: For 9edestal installations, see additional installation instructions included with the pedestal. For stacking, installations, see additional installtion instructions included with the stacking kit.
Page 4
LOCATION OF YOUR WASHER DO NOTINSTALL YOUR WASHER: In an area exposed to dripping water or outside weather Carefully return the washer to an upright position. conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) Carefully move the washer to within 4 feet (122cm) of the operation.
Page 5
INSTALLATION STOP HOSE TABS DRAIN Leve/ing the Washer Excessive noise and vibration can be prevented by properly leveling the washer. SPRING CLAMP For free standing installation and with the washer in it's PROVIDED final position, place a level on top of the washer. Adjust HOSE the leveling legs so the washer is level front-to-rear side-to-side...
Page 6
PARTS If replacements parts are needed for your washer, contact the source where you purchased your washer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for the Frigidaire Company Authorized Parts Distributor nearest you. Destroy the carton and plastic bags after the Cable washer is unpacked.
Need help?
Do you have a question about the ATF7000EE0 and is the answer not in the manual?
Questions and answers