White-Westinghouse XHE User Manual page 16

Installation Instruction, continued
Water inlet
Do not use the hose from your previous appliance to connect to
the water supply.
1. Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring nut
again to prevent water leaks.
NOTE
A wiring diagram and technical data sheet are located inside
the dryer console.
To remove the console faceplate follow the directions below:
1. Disconnect dryer from electrical source.
2. Remove the hole plugs on the back of the console
housing.
3. Insert a small, straight blade screw drive to gently pry
downward on each faceplate retaining tab.
4. Gently lay the console faceplate forward without pulling
wires to access technical/wiring diagram.
5. When fi nished with repair, return sheet inside console,
snap faceplate to console housing and reinstall hole
plugs.
16
2. Connect the hose to a tap with
a 3/4" thread. Always use the
hose supplied with the ap-
pliance. The inlet hose must
not be lengthened. If it is too
short and you do not wish to
move the tap, you will have to
purchase a new, longer hose
specially designed for this type
of use.
Water drainage
The drain hose must not be kinked. The end of the drain
hose can be positioned in these ways:
Directly into a drain pipe at a height of not less than 85 cm
and not more than 200 cm. The end of the drain hose must
Hooked over the edge of a sink.
In this case, make sure the end
cannot come unhooked when the
machine is emptying.
always be ventilated, i.e. the inside
diameter of the drain pipe must be
larger than the outside diameter of
the drain hose.
TECH DATA SHEET/
WIRING DIAGRAM