Error Display - Panasonic NA-140VG4 Operating Instructions & Installation Instructions

Unable to drain
Door is open
Unable to spin-dry
Unable to supply
water
What to do
Check the drain hose for any of the following problems .
- It clogs up .
- Its tip is immersed in water .
- It extends further than 3 m .
- The water is frozen .
Clean the drain filter if it clogs up . (See page 23 .)
After correcting the problem, open and close the door, and then
start the wash again .
What to do
Make sure that the door is shut properly .
The appliance has been designed to detect unbalanced loads,
particularly small loads, in order to ensure quiet operation and
achieve the best results .
This is not a malfunction . Perform any of the following solutions .
What to do
- If the laundry is too heavy, untangle clumps of clothing .
- If the laundry such as a blanket is too heavy, reduce the load .
- If the laundry is too light, add one or two bath towels .
- If the appliance is on an unstable or uneven surface, change
the setting location .
After correcting the problem, open and close the door, and then
start the wash again .
What to do
Check for any of the following problems .
- The tap is closed .
- The water pipe or hose is frozen .
- The water supply has been disrupted .
- The water supply filter is clogged . (See page 24 .)
After correcting the problem, open and close the door, and then
start the wash again .
If the red mark appears in the hose with a water supply valve, the
water supply has stopped .
You should replace with a new hose .
Hose with water supply valve (AXW12C-7SR0)
An error display starting with H .
What to do
Press the Off button . If the display stays on, or if it reappears
when you press the Start button, unplug the appliance and
contact your local Customer Service Centre .

Error Display

Troubleshooting - 29