Toshiba 50L2300U User Manual page 53

Setting upyour'IV _
Auto Tuning
NOTE ,:. YoumustsetuptheANT/CABLE inputsource before
programming channels. See"ANT/CABLE IN"on page 51.
o:o Theautomatic c hannel p rogramming p rocess will erase
channels thatwerepreviously programmed i ntotheTV's
memory.
•:° TotunetheTVtoa channel n otprogrammed inthechannel
memory, y oumustusetheChannelNumber buttonsonthe
remote control.
Programming c hannels w hentheANT/CABLE inputis
configured for Cable will takesubstantially l ongerthanwhenthe
antenna inputis configured forAntenna. This isnormal;
however, oncechannel p rogramming isfinished, y oushouldnot
have to repeat theprogramming process againunless yourCable
TVservicelineup changes significantly.
To program channels automatically:
1 Configure the antenna input source, if you have not already
done so, see "ANT/CABLE IN" on page 51.
2 Press the MENU button and open the Installation menu.
3 Highlight Channel Tuning, and then press the ENTER button.
(Sample hnage) Setup menu - Installation selection
4 Highlight Auto Tuning, and then press the ENTER button to
open the Channel Program menu to begin channel
programming.
(Sample hnage) Installation menu - Channel selection