HP ProBook 4230s Maintenance And Service Manual page 80

f. Modem module (see
g. System board (see
h. Fan (see
i. Heat sink (see
Remove the processor:
1. Position the system board upside-down.
2. Use a flat-bladed screwdriver to turn the processor locking screw (1) one-half turn
counterclockwise until you hear a click.
3. Lift the processor (2) straight up and remove it.
NOTE:
on the processor slot when you install the processor.
Reverse this procedure to install the processor.
72 Chapter 4 Removal and replacement procedures
Modem module on page
System board on page
Fan on page 67)
Heat sink on page
The gold triangle (3) on the processor must be aligned with the triangle (4) embossed
61)
63)
69).