Door Lock/Unlock - Prime Security AMX98 Installation Manual

Normally Closed Normally Closed
1. Locate the ignition switch wireloom under the dashboard. 1. Locate the ignition switch wireloom under the dashboard.
2. Use a voltmeter to find the one wire that will show +12 volts while the 2. Use a voltmeter to find the one wire that will show +12 volts while the
ignition key is in the cranking cycle only. This should be the starter ignition key is in the cranking cycle only. This should be the starter
solenoid wire. solenoid wire.
3. Cut the starter solenoid wire. Test by trying to crank the starter with the 3. Cut the starter solenoid wire. Test by trying to crank the starter with the
ignition key. If it will not crank, you have the correct wire. ignition key. If it will not crank, you have the correct wire.
4. Connect one YELLOW wire to the key side. 4. Connect one YELLOW wire to the key side.
5. Connect the other YELLOW wire to the starter side. 5. Connect the other YELLOW wire to the starter side.
Normally Open Normally Open
1. Unplug the YELLOW wire from relay terminal 87A and insert the 1. Unplug the YELLOW wire from relay terminal 87A and insert the
YELLOW wire into relay terminal 87. YELLOW wire into relay terminal 87.
2. Locate the ignition switch wireloom under the dashboard. 2. Locate the ignition switch wireloom under the dashboard.
3. Use a voltmeter to find the one wire that will show +12 volts while the 3. Use a voltmeter to find the one wire that will show +12 volts while the
ignition key is in the cranking cycle only. This should be the starter ignition key is in the cranking cycle only. This should be the starter
solenoid wire. solenoid wire.
4. Cut the starter solenoid wire. Test by trying to crank the starter with the 4. Cut the starter solenoid wire. Test by trying to crank the starter with the
ignition key. If it will not crank, you have the correct wire. ignition key. If it will not crank, you have the correct wire.
5. Connect one YELLOW wire to the key side. 5. Connect one YELLOW wire to the key side.
6. Connect the other YELLOW wire to the starter side. 6. Connect the other YELLOW wire to the starter side.
7. Program the alarm module for Normally Open (N.O.) starter disable (see 7. Program the alarm module for Normally Open (N.O.) starter disable (see
"Programming Table for Alarm Features"). "Programming Table for Alarm Features").

Door Lock/Unlock

Door Lock/Unlock
The alarm has on-board relays to lock and unlock the doors. It also has a The alarm has on-board relays to lock and unlock the doors. It also has a
second unlock (-) output wire (GREEN) that will allow you to do Two-Stage second unlock (-) output wire (GREEN) that will allow you to do Two-Stage
Unlock. The second stage unlock wire provides a 400 ma, 0.75 second (-) Unlock. The second stage unlock wire provides a 400 ma, 0.75 second (-)
output when activated. output when activated.
Two-Stage Unlock Two-Stage Unlock
CAUTION: Be sure to verify the type of door lock system you are CAUTION: Be sure to verify the type of door lock system you are
I I
working with. Carefully follow the door lock/unlock diagrams on working with. Carefully follow the door lock/unlock diagrams on
pages 9-12. pages 9-12.
1. Press the remote arm/disarm button once and the driver door only will 1. Press the remote arm/disarm button once and the driver door only will
unlock. unlock.
2. Press the remote arm/disarm button again within 3 seconds and the 2. Press the remote arm/disarm button again within 3 seconds and the
passenger doors will unlock. passenger doors will unlock.
8
AMX98(3) Rev. A - Installation Manual 12/98