Pace Sky box Using Manual page 40

If the setup didn't work
If you followed the steps carefully but can't see the TV Guide menu at the end of it, follow these
simple steps:
1 Check and make a note of which TV channel you use for watching Sky digital TV.
2 Press tv on your remote control.
3 Hold down select and the green key together until the red light on your remote control blinks
twice (this is after about 2 seconds).
4 Key in the number your TV uses for watching Sky digital TV and press select.
The red light blinks, meaning the remote control settings are made properly.
Alternative setup
If your TV's brand isn't listed on page 35, you can try an alternative setup. This involves
programming your remote control to the TV's specifi c model code instead of the brand code,
as follows:
1 Firstly, you need to check the code for your TV model:
Go to Interactive > Sky Customer Service > Technical Assistance > For all Sky remote controls.
Follow the relevant options until you get to the code for your model number then make a
note of the code.
2 Point the remote control away from the TV and Sky box and press the tv key.
3 Press and hold the select and red keys together until the red light blinks twice.
4 Enter the code. If it's a 3-digit number, press select after the code.
5 Press Sky to complete the setup.
6 Now check the settings; point the remote control at the Sky box and press tv then
number 3. You should now be able to see a terrestrial TV channel.
36 USING YOUR SKY BOX
If you have tried all the setup
options and still can't use
your remote control with
your TV, call Sky Customer
Service.