ECS H67H2-M2 Manual page 23

SATA3~6: Serial ATAII connectors
These connectors are used to support the Serial ATA 3Gb/s devices, simpler disk drive
cabling and easier PC assembly. It eliminates limitations of the current Parallel ATA
interface. But maintains register compatibility and software compatibility with Par-
allel ATA.
Pin Signal Name
1
Ground
3
TX-
5
RX-
7
Ground
F_USB1~4 : Front Panel USB 2.0 headers.
The motherboard has three USB 2.0 headers supporting eight USB 2.0 ports. Addi-
tionally, some computer cases have USB 2.0 ports at the front of the case. If you
have this kind of case, use auxiliary USB 2.0 connector to connect the front-
mounted ports to the motherboard.
Unlike F_USB2~4 in this mainboard, F_USB1 supports EZ Charger technology,
provides about 1A current than general USB port in off mode for USB devices. It is
useful and excellent, especially for the iPhone, iPad and iPod touch devices that need
a large amount of current for faster recharging within less time.
Pin Signal Name
1
USBPWR
2
USBPWR
3
USB_FP_P0-
4
USB_FP_P1-
5
USB_FP_P0+
6
USB_FP_P1+
7
GND
8
GND
9
Key
10
USB_FP_OC0
Please make sure that the USB cable has the same pin assignment as
indicated above. A different pin assignment may cause damage or system
hang-up.
Installing the Motherboard
Pin Signal Name
2
TX+
4
Ground
6
RX+
-
-
Function
Front Panel USB Power
Front Panel USB Power
USB Port 0 Negative Signal
USB Port 1 Negative Signal
USB Port 0 Positive Signal
USB Port 1 Positive Signal
Ground
Ground
No pin
USBOC-
19