Honda Prelude 2003 Owner's Manual page 23

Child Safety
To install a locking clip, do the
following:
1. Place the child restraint in the
desired position. Route the lap/
shoulder belt through the
restraint according to the seat
manufacturer's instructions.
2. Insert the latch plate into the
buckle. Pull on the shoulder part
of the belt to make sure there is
no slack in the lap portion.
3. Tightly grasp the belt near the
latch plate. Pinch both parts of
the belt together so they won't
slip through the latch plate. Un-
buckle the seat belt.
Driver and Passenger Safety
4. Install the locking clip as shown.
Position the clip as close as
possible to the latch plate.
5. Insert the latch plate into the
buckle. Push and pull on the
child seat to verify that it is held
firmly in place. If it is not, repeat
these steps until the restraint is
secure.
Using Child Restraints with
Tethers
150 mm (5.9 in)
230 mm
(9.1 in)
Your Honda has two attachment
points for tether-style child seats.
Use the dimensions in the above
illustration to locate the attach-
ment point you want to use. Cut a
12.7 mm (1/2 inch) diameter hole in
the rear shelf.