Dodge 2004 Neon SX2 Diagnostic Manual page 84

SEAT SQUIB SHORT TO BATTERY —
TEST
2 WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED SEAT BACK PAD-
DED SIDE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN
SERIOUS OR FATAL INJURY.
Disconnect the Seat Airbag connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Seat Airbag connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read SIACM active DTC's.
Does the DRBIII display SEAT SQUIB SHORT TO BATTERY?
Yes → Go To 3
No
3 WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED SEAT BACK PAD-
DED SIDE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL
INTO THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN
SERIOUS OR FATAL INJURY.
Disconnect the Airbag Load Tool Jumper.
Disconnect the Side Impact Airbag Control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool SIACM adaptor to the SIACM connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
Measure the voltage of the Seat Squib Line 1 and Line 2 circuits between the Seat
Airbag connector and ground.
Is any voltage present on either circuit?
Yes → Repair Seat Squib Line 1 or Line 2 shorted to battery.
No
ACTION
→ Replace Seat Airbag in accordance with the Service Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
→ Replace the Side Impact Airbag Control Module in accordance
with Service Instructions. WARNING: IF THE SIDE IMPACT
AIRBAG CONTROL MODULE IS DROPPED AT ANY TIME, IT
MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
77
AIRBAG
APPLICABILITY
All
All