Mazda 2009 CX-9 Owner's Manual page 94

CX-9_8Z66-EA-08F_Edition3 Page94
Tuesday, March 31 2009 1:51 PM
Knowing Your Mazda
Advanced Keyless Entry and Start System
NOTE
In the following cases, the KEY warning light
(red) illuminates and the engine will not start.
The advanced key battery is dead.
l
The advanced key is out of operational
l
range.
The advanced key is placed in areas where
l
it is difficult for the system to detect the
signal (page 3-7).
A key from another manufacturer similar to
l
the advanced key is in the operational
range.
8. Turn the ignition switch to the ACC
position while pushing the start knob
in.
9. Turn the ignition switch from the ACC
position to the START position and
hold (up to 10 seconds at a time) until
the engine starts.
CAUTION
Do not try the starter for more than
10 seconds at a time. If the engine
stalls or fails to start, wait 10 seconds
before trying again. Otherwise, you
may damage the starter and drain
the battery.
10. After starting the engine, let it idle for
about 10 seconds.
3-12
Form No.8Z66-EA-08F
Black plate (94,1)
NOTE
In extremely cold weather or after the
l
vehicle has not been driven in several days,
let the engine warm up without operating
the accelerator.
Whether the engine is cold or warm, it
l
should be started without use of the
accelerator.
Turning off the engine
1. Move the shift lever to the P position.
2. Turn the ignition switch from the ON
position to the ACC position.
NOTE
When the engine is turned off and the ignition
switch it turned from the ACC position to the
LOCK position, the KEY indicator light
(green) flashes in the instrument cluster for
about 30 seconds if the battery power of the
advanced key is low. Replace the battery with a
new one.
Refer to Battery Replacement (page 3-6).
3. Push in the start knob from the ACC
position and turn it to the LOCK
position.
CAUTION
When leaving the vehicle, make sure
the ignition switch is turned to the
LOCK position.