Troubleshooting - D-Link Broadband DSL-254B User Manual

Table of Contents

Appendix A – Troubleshooting

This chapter provides solutions to problems that might occur during the installation and operation of the DSL-2542B. Read the following

descriptions if you are having problems. (The examples below are illustrated in Windows® XP. If you have a different operating system, the

screenshots on your computer will look similar to the following examples.)

1. How do I configure my DSL-2542B Router without the CD-ROM?

• Connect your PC to the Router using an Ethernet cable.

• Open a web browser and enter the address http://192.168.1.1

• The default username is 'admin' and the default password is 'admin'.

• If you have changed the password and cannot remember it, you will need to reset the Router to the factory default setting (see question 2),

which will set the password back to 'admin'.

Note:

Please refer to the next section "Networking Basics" to check your PC's IP configuration if you can't see the login windows.

2. How do I reset my Router to the factory default settings?

• Ensure the Router is powered on.

• Press and hold the reset button on the back of the device for approximately 5 to 8 seconds.

• This process should take around 1 to 2 minutes.

Note:

Resetting the Router to the factory default settings will erase the current configuration settings. To reconfigure your settings, login to the Router as

outlined in question 1, then run the Quick Setup wizard.

D-Link DSL-2542B User Manual