Sharp VL-H870S Service Manual page 7

VL-H870U
VL-H860S/H/VL-H870S
VL-H875U
VL-H890S/VL-H94E
VL-H890U
VL-H96E/VL-H960E
3-2. REMOVAL OF THE CAMERA PARTS
Note:
Before removing the Cabinet, turn off the power supply,and ascertain that the battery has been removed.
(c)
1. Remove the screws (b)LX-HZ0018TAFF(1pc.), (a)LX-HZ
0 0 1 8 T A F N ( 1 p c . ) , ( c ) L X - H Z 0 0 4 5 T A F N ( 1 p c . ) a n d
(d)XiPSF20P04000(1pc.), pull out the Front cabinet.
(g)
Remove
2. Remove the screws (g)LX-HZ0045TAFF(2pcs.) and the Cam-
era rear grip cover .
3. Remove the connector.
(a)
(b)
(d)
Pull out
Camera front cabinet
Camera rear grip cover
(g)
Connector
(b)
(d)
4. Remove the screws(b)LX-HZ0018TAFF(1pc.),(c)LX-
HZ0045TAFN(2pcs.) and (d)XiPSF20P04000(1pc.),pulling out
the Camera rear Cabinet, and remove the Speaker connec-
tor.
(c)
Tilt Frame C
Claw
5. Remove the screw (c)LX-HZ0045TAFN(1pc.) and pull out
the Tilt Frame C.
Pull out the Tilt Frame C. at right angle, because of closing the
claw.
Then, pull out the battery catcher connector from the Tilt
Frame C.
3-4
VL-H860S/H/VL-H870S
VL-H890S/VL-H94E
VL-H96E/VL-H960E
(c)
(c)
Pull out
Speaker connector
Battery catcher connector
Pull out