Gigabyte GA-X99-SOC Champion User Manual page 68

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go to
Chipset\PCH SATA Configuration, make sure SATA Controller is enabled. To create RAID, set Configure
SATA as to RAID (Figure 1). If you do not want to create RAID, set this item to IDE or AHCI.
Step 2:
If you want to configure UEFI RAID, follow the steps in "C-1." To enter the legacy RAID ROM, save the settings
and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Configuring SATA Hard Drive(s)
Figure 1
- 68 -