Advertisement
OPTION FUNCTION
If need to add option function (humitidy sensor, speed controller ect.),
put relevant power box in the place showed right, fixed it with screws,
and insert the plug from the box into the suitable wire panel.
Connect electrical wiring refer to "CONNECT ELECTRICAL WIRING" .
INSTALL GRILLE
Install ceiling material to complete the ceiling construction. Then, cut around
the fan housing.
To attach the grille assembly to the fan housing, pinch the grille springs on
the sides of the grille assembly, and position the grille into the housing with
the grille springs in the appropriate slots. Push the grille assembly towards
the ceiling to secure.
SERVICE PARTS
PART
PART NAME
1
Grille Assembly (includes part 2)
2
Grille Spring
3
Motor
4
Blower
5
Wire Panel / Harness Assembly
6
Junction box cover
7
Adaptor
8
Hanger Bar Kit
9
Blower Wheel
Housing
10
a
Screw
b
Nut, Hex Lock
c
Screw
d
Screw
* Blower Assembly includes part 4, 3, 9, a, b, c.
WARNING: Before replacing, be sure to turn off power at power source.
WARRANTY
S&P USA Ventilation Systems, LLC. & S&P Canada Ventilation Products, Inc. warrants to the original end user of its
products that our exhaust fans will be free from defects in materials and workmanship for a period of Five (5) years from
the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT
NOT LIMITED TO IMPLIED WARRANTIES OF SUITABILITY FOR A PARTICULAR PURPOSE.
During this five year period, S&P will, at its option, repair returned products or parts, or provide replacement products or
parts, without charge, for any product or part which is found to be defective under normal use.
This warranty does not cover normal maintenance and service or any parts that have been subject to misuse, negligence,
accident, improper maintenance or repair, faulty installation or installation contrary to recommended installation instructions.
S&P's obligation to repair or replace, at S&P's option, shall be the purchaser's sole and exclusive remedy under this
warranty. No labor or materials are covered by this warranty. S&P shall not be liable for incidental damages arising out of
or in connection with product use or performance.
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
To qualify for warranty service, you must notify S&P at the address or telephone number stated below, provide the model
number and part identification, and describe the nature of any defect in product or part. You may be required to ship a
defective part to S&P. There will be no charge for shipping repaired or replacement parts from S&P to you if your address
is in the United States or Canada. At the time of requesting warranty service, you must present evidence of the original
purchase date.
S&P USA Ventilation Systems,LLC.
6393 Powers Avenue Jacksonville, FL 32217
P. 904-731-4711
F. 904-731-8322
www.spvg-northamerica.com
Qty.
1
8
2
1
1
7
1
d
1
1
6
d
4
5
1
1
3
3
4
3
S&P Canada Ventilation Products, Inc.
5600 Ambler Drive Mississauga, ON L4W 2K9
P. 866-733-0233
F. 866-358-5346
www.solerpalaucanada.com
4
4
3
2
1
Screw
10
9
c
b
a
Advertisement
