I.int Filter; Operating Instructions - GE DDP1370G Use And Care Manual

read the WORTANT
instructions on page 5. If you do
mix various types of fabrics in your
load, set the controls for the
lighter-weight fabrics and remove
when dry. Reset the controls for the
remaining heavier fabrics.
Controls SettiW Guide
I I
Fabric Cottons & Linens
Clean the lint filter before dryiW every load.
L
—
SHRINKAGE,
KNITS
the risk of fire, electric shock, or injury to persons,
Clean lint filter. See below.
Close door. Door must be closed
before dryer will operate.
See the Controls Setting Guide
below.
Delicate Setting
(up min.)
Damp tied
Sheers
for hn@
Clean the lint filter by putting your
moistened fingers at one comer of
the filter and wiping in a sideways
: :::::::::::. : . : . !
motion all the way across to the
other comer. Periodically remove
Relaxation shrinkage
can occur in kmt fabrics that have been improperly stretched
and elongated by the m-anufacturer. When this occurs, garment maybe-pressed back into
shape after each wash and dry cycle.
gradually removed by laundering. Maybe noticed in older garments that have been
laundered many times without previous shrinkage. Treat as for Relaxation Shrinkage above.
Model DD~75G
the Controls
Fluff (No Heat)
min. min. 10 min.
Small
Load
Plastics,
Synthetics &
Blends
_.
cycle and select correct drying time
for load size and type.
to start dryer. (@ning door during
operation stops the dryer. To re-start,
close the door and push START
button again.)
The times su~ested are to be
followed as a guide. You may find
that best results are obtained for
some of your fabrics by setting
times to either side of these
recommendations.
and insert the suction hose from a
vacuum cleaner into the opening.
Do not operate the dryer without
the lint filter in place.
..\
.