Configure The Router; Configure The Router; Access Router’s Homepage - Mobily BB@work NTC-30 Series Installation Manual

Powering your Router
Configure the Router
The outdoor router can be powered via DC power supply or Power over Ethernet (PoE).
Step 1: Access Router's Homepage
DC power option
Your outdoor router's homepage can be accessed by using the web address via default IP
address http://192.168.1.1 or alternatively via URL http://my.router.
Your router is provided with a waterproof DC jack allowing it to be powered by a 9~28V DC power
This URL opens the management console, where you can
supply.
• View the status of your router.
1. On the bottom interface panel of the router, locate the DC power port and unscrew the
protective cap to expose the connection pins.
• Make changes to the routers configurations.
Admin manager account
Username
Password
The admin manager account allows user to manage all settings of the router except functions
such as Firmware Upgrade, Device Configuration Backup and Restore, Mobile Broadband
2. Connect the DC power jack as shown below to the DC power port of the router and turn the
Settings and Reset to Factory Default Settings, which are privileged only to the root manager
metal securing ring clockwise while pushing the conector in to secure the DC jack in position.
account.
To access the homepage:
1. Open your web browser and enter the IP address http://192.168.1.1 or http://my.router.
2. Click Login and type the username/password for the Admin manager account or Root
manager account.
3. Then click on Submit.
3. At the other end of the cable, wire the red (positive +) and black (grounding) wires to your
9~28V DC power supply source.
Power
NOTE: First time users should use Root Manager account to configure Mobile Broadband
2
settings.
Admin
Admin
1
Pin Signal
1
2
Root manager account
Username
Password
Description
V+ Voltage+
GND Ground
Root
Admin
04
10
10