Marantz SR6010 Owner's Manual page 213

Contents Connections
Error messages
An error message is displayed if Audyssey
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples
No speakers found.
Ambient noise is too high or level is too
low
Front R : None
Front R : Phase
Front panel Display
Playback
® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
Error details
Sound calibration microphone is not
0
detected.
Not all speakers could be detected.
0
There is too much noise in the room.
0
Speaker or subwoofer sound is too low.
0
The displayed speaker could not be
0
detected.
The displayed speaker is connected with the
0
polarity reversed.
Rear panel
Settings
Connect the included Sound calibration microphone to the
0
SETUP MIC jack of this unit.
Check the speaker connections.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Check the speaker installation and the direction in which the
0
speakers are facing.
Adjust the subwoofer's volume.
0
Check the connections of the displayed speaker.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
0
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select "Ignore", then press
ENTER.
213
Remote
Tips Appendix
Measures
Index