Advertisement
L1
L2
L3
S1.1
S1.2
S1.3
Program
S1.1-
Automatic programs
S1.4
In this program the drying time is controlled by the microprocessor, depending
on the moisture level measured by the moisture sensor and the dryness of the
chosen program. The temperature is controlled by the thermistor to 75°C.
By very small loads or empty machine, these programs will use a drying time of
about 20 minutes.
S1.1
Extra dry
S1.2
Normal dry 1
S1.3
Normal dry 2
S1.4
Iron dry
The programs are ended by a cooling-down sequence, which goes on till
the air temperature is ca 35°C or for a maximum time of 15 min. D2 indicates
"C" during the cooldown period.
S1.5
Timed program
One press on S1.5 means 5 min. drying time + cool down till the air temperature
is 35°C or maximum 15 minutes.
Continued pressings increases the drying time to 10, 15, 20, 30, 50, 60, 70, 80,
90, C (just cool air 15 min.), 5, 10 etc.
Drying temperature 50°C.
D1 and D2 indicates drying time in minutes. After starting the machine counts
down with 1 for each minute. Cool down sequence is indicated with "C".
S2
Low temperature
Lowers the temperature in program S1.1-Sl.4 from 75°C to 50°C .
S2 is automatically activated in program S1.5.
S3
Intermittent action
Means that the motor rotates for 3 seconds every minute during one hour after
end of program.
S4
Buzzer
A buzzer tone of 3 seconds (ca 65 dBA) indicates end of program.
TD 77
L4
L7
L6
S1.4
S4
S3
D1
D2 D3 D4
L5
S2
S1.5
S6
S5
Advertisement
