Before You Start; Setting The Date And Time - Danfoss CP715 Si Installation & User's Instructions

Electronic, 2-channel common timebase programmer for heating & hot water

Hide thumbs Also See for CP715 Si:

Table of Contents

Before you start

Open the ﬂ ap on the front of the clock. Press the RESET button

using a non-metallic object (e.g. pencil/matchstick) until you

hear a click and the 2 red lights on the front of the unit ﬂ ash

once.

This will stop and restart the

electronics,

factory set time and date settings.

To fully reset the unit see page 319.

Choice of 24hr or AM/PM display

Press and hold DAY/HOL & NEXT

ON/OFF for 1.5 seconds to toggle

between 24hr clock and AM/PM

display, as required.

These settings are made during

manufacture and only need to be

made in the unlikeley event that the

unit has lost the settings.

Setting the Date

Press and hold PROG for 5 seconds

to display year.

Use the + or - buttons to set the

correct year.

without

losing

the

DAY/HOL

Table of Contents

Show Quick Links

Table of Contents