Connecting Other Components; Connecting The Power Cord - Pioneer CDJ-800MK2 Operating Instructions Manual

2. Control cord connections for relay play
By using the accessory control cord to connect the control connectors of two DJ CD Players, automatic relay play can be performed.
( P. 20)
CDJ-800MK2

3. Connecting other components

A Connecting a stereo amplifier (when not using DJ mixer)
Connect to CD or AUX IN connectors.
Stereo amplifier
(Do not connect to PHONO IN connectors.)
B Connecting a component equipped with DIGITAL IN connectors
CD recorder or amplifier with
DIGITAL IN connectors, etc.
¶ The DIGITAL OUT connectors produce audio data only (without subcodes; CD graphics are not supported).
Depending on the CD recorder or other component connected, some recording or other functions may be limited. For details,
consult the operating instructions for the connected component.
4. Connections for copying one player's recorded data to another player
Using either the accessory control cord or a commercial mini-plug cord, connect the DATA IN/OUT connectors for two CDJ-800MK2*
players. In this way, the data (cue points, loops) recorded in one player can be copied to the other player ( P. 20).
* It is possible to copy data from a CDJ-800 player to a CDJ-800MK2, but not the reverse.
CDJ-800MK2

5. Connecting the power cord

After completing all other connections, connect one end of the accessory power cord to the AC inlet on the rear side of the player, and
connect the other end to a standard AC wall outlet, or to the auxiliary power outlet on your amplifier.
Accessory control cord
Accessory audio cable
Commercially available
coaxial digital signal cable
Accessory control cord or a
commercial mini-plug cord
Before Operating (Names and Functions of Parts)
CDJ-800MK2
CDJ-800MK2
CDJ-800MK2
CDJ-800MK2
Connections
9