Trowel Components - MULTIQUIP JH55C Operation And Parts Manual

15
Figure 2. Trowel Control and Components
Figure 2 and Figure 3 shows the location of the basic
controls or components, for the trowel. Listed below is a
brief explanation of each control or component.
1. Access Panel — Allows access to the blade area.
NEVER run the trowel with this access panel removed.
2. Engine — Honda 4.8 HP gasoline engine.
3. Lifting Bale — Attach a suitable lifting device to lifting
bale whenever lifting of the trowel is required.
4. Throttle Lever — Controls engine speed. Returns
engine to idle when released.
5. Left Clutch Lever —Squeeze to engage clutch.
4-blade rotation will start. This is the primary control
lever.
6. Vibratory Handle Bar — Installed rubber shock
mounts/isolators reduces vibration when the trowel
is operating.
PAGE 16 — JH55C WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #2 (9/4/15)
3
2
1

TROWEL COMPONENTS

6
5
7
10
7. Star Wheel Pitch Knob (4-Blade)— To adjust the pitch
of the blades, rotate the star wheel clockwise to pitch
blades upwards. Rotate star wheel counterclockwise
to pitch blades flat (no pitch).
8. Handle Bar Pad — Foam rubber pad that protects the
body when coming in contact with handle bar.
9. Hand Grips — When maneuvering of the trowel is
required ALWAYS place both hands on each grip to
operate the trowel. Replace hand grips when they
become worn or damaged.
10. Star Wheel Knob (Handlebar Adjuster) — Changes
the angle/height of the handlebar. Loosen the star
wheel (turn counterclockwise) to place the handlebar
in the desired position. Tightewn the star wheen (turn
clockwise) to lock handlebar.
8
9
4