Battery Care; Battery Disposal - Dremel 800-49 Operating/Safety Instructions Manual

Table of Contents

Advertisement

DM 2610945859 05-07
Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual. Do not
substitute any other charger. Use only Dremel
approved chargers with your product. See
Functional Description and Specifications.
Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in any
way. Replace damaged cord or plugs
immediately. Incorrect reassembly or damage
may result in electric shock or fire.
Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. If battery case is cracked or
otherwise damaged, do not insert into
charger. Battery short or fire may result.
Charge
only
rechargeable batteries. See Functional
Description and Specifications. Other types of
batteries may burst causing personal injury
and damage.
Charge battery pack in temperatures above
+40 degrees F (4 degrees C) and below
When batteries are not in
!
WARNING
tool or charger, keep them
away from metal objects. For example, to
protect terminals from shorting DO NOT
place batteries in a tool box or pocket with
Do not attempt to disas-
!
WARNING
semble the battery or
remove any component projecting from the
battery terminals. Fire or injury may result.
Prior to disposal, protect exposed terminals
with heavy insulating tape to prevent shorting.
7/10/07
8:43 AM
Battery/Charger
Dremel
approved

Battery Care

Battery Disposal

Page 5
+105 degrees F (41 degrees C). Store tool
and battery pack in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent
serious damage to the battery cells.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery
liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact with
skin, wash quickly with soap and water. If the
liquid contacts your eyes, flush them with
water for a minimum of 10 minutes and seek
medical attention.
Place charger on flat non-flammable
surfaces and away from flammable
materials when re-charging battery pack.
The charger and battery pack heat during
charging. Carpeting and other heat insulating
surfaces block proper air circulation which may
cause overheating of the charger and battery
pack. If smoke or melting of the case are
observed unplug the charger immediately and
do not use the battery pack or charger.
Use of an attachment not recommended or
sold by Dremel may result in a risk of fire,
electric shock or injury to persons.
nails, screws, keys, etc. Fire or injury may result.
DO NOT PUT BATTERIES INTO FIRE OR
EXPOSE TO HIGH HEAT. They may
explode.
At the end of the battery's useful life, do not
throw out the battery. Please bring your
battery to a proper battery disposal location
or contact your local Dremel distributor.
-5-

Advertisement

Table of Contents
loading

Table of Contents