Hanging And Wiring The Fan - Hunter Type A Installation And Operation Manual

Step 3-1
Dual Switch Wiring
Single Switch Wiring
Step 3-6 (Single)
3 • Hanging and Wiring the Fan
3-1. Lift the motor assembly and hook the three tabs over the handles,
one at a time.
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Tab
Wall switches are not included. Select an acceptable general-use switch
Handle
in accordance with national and local electrical codes.
3-2. Before attempting installation, make sure the power is still off.
3-3. To connect the wires, hold the bare metal leads together and place
Wire Nut a wire nut over them, then twist clockwise until tight. For all these
connections use the wire nuts provided.
3-4. Connect the bare or green ground wire (grounded) from the
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
3-5. Connect the white wire (ungrounded) from the ceiling to the
white wire (ungrounded) from the fan.
3-6. Connect the remaining wires as follows:
Dual Switch Wiring:
Step 3-6 (Dual)
Single Switch Wiring:
making connections.
3-7. Turn the splices upward and push them carefully back through the
ceiling plate into the outlet box.
3-8. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the
outlet box.
42815-01 • 10/02/07 • Hunter Fan Company
• The black wire (ungrounded) from the ceiling to the black wire
(ungrounded) from the fan
• The black/white wire (ungrounded) from the fan to the wire
(ungrounded) for the wall switch
• The black wire (ungrounded) from the ceiling to the black
(ungrounded) and the black/white wire (ungrounded) from
the fan
CAUTION: Be sure no bare wire or wire strands are visible after
6