Hanging And Wiring The Fan - Hunter 21327 Installating And Operation Manual

3 • Hanging and Wiring the Fan
Step 3-1
Dual Switch Wiring

Single Switch Wiring
Hunter Fan Company
3-1. Lift the motor assembly and hook the three tabs over the handles,
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Tab
Wall switches are not included. Select an acceptable general-use switch
Handle
in accordance with national and local electrical codes.
3-2. Before attempting installation, make sure the power is still off.
3-3. To connect the wires, hold the bare metal leads together and place
Wire Nut
3-4. Connect the bare or green ground wire (grounded) from the
3-5. Connect the white wire (ungrounded) from the ceiling to the
3-6. Connect the remaining wires as follows:
Step 3-6 (Dual)
3-7. Turn the splices upward and push them carefully back through the
3-8. Spread the wires apart, with the grounded wires on one side of
Step 3-6 (Single)
one at a time.
a wire nut over them, then twist clockwise until tight. For all these
connections use the wire nuts provided.
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
white wire (ungrounded) from the fan.
Dual Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black wire
(ungrounded) from the fan
• The black/white wire (ungrounded) from the fan to the wire
(ungrounded) for the wall switch
Single Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black
(ungrounded) and the black/white wire (ungrounded) from
the fan
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
ceiling plate into the outlet box.
the outlet box and the ungrounded wires on the other side of the
outlet box.
42826-01 • 2/25/07