Before You Begin - Marvin Window User Manual

Before You Begin

Installer and Builder Information
S Read these instructions thoroughly BEFORE beginning to
install your Marvin window product.
S Always provide a copy of these instructions for the current
or future building owner.
S Plan sizing of rough opening and clearance from exterior
finishing systems to allow for normal materials shrinkage or
shifting (e.g. wood structure with brick veneer, allow
adequate clearance at sill). Failure to do so can void the
Marvin warranty coverage.
S Refer to the Technical Installation Specifications section
for technical specifications regarding the installation of this
product. These installation requirements as well as the
details in this section must be followed to achieve the
advertised design pressure (DP) rating of this product.
Aftermarket Products
Alterations to Marvin products including window films, insulating or reflective interior window treatments or additional glazings
can cause excessive heat buildup and/or condensation. They may lead to premature failures not covered under warranty by
Marvin Windows and Doors.
Before purchasing or applying any product that may affect the installation or performance of Marvin windows contact the
manufacturer of aftermarket product/glazings that are not supplied by Marvin and request written product use, associated
warranties and damage coverage. Provide this information and warranties to the end user and/or building owner for future
reference.
Hazard Notations
Please familiarize yourself with the following hazard notations used throughout this instruction.
Caution
Mistakes or misuse
could cause damage
to the window or
result in faulty
installation and unit
performance.
You Will Need to Supply
Safety glasses
Level
Hammer
Insulation
1
Perimeter sealant
Backing material (foam backing rod)
Low expansion foam insulation
Appropriate fastener (see Jamb/Sill Screw Chart)
3
Construction adhesive
NOTE: Numbers listed in parentheses ( ) are metric
equivalents in millimeters rounded to the nearest whole
number.
1
Sealant must be Grade NS Class 25 per ASTM C920 and compatible with building exterior and window surface.
2
Optional, use low expansion foam insulation only. Foam and foam application must comply with ASTM E2112, section 5.9.2.
3
APA rated AFG−01 spec
19970019
2012−04−10
Warning Seek Assistance
Mistakes or misuse
could result in individual is necessary
personal injury and/or
severe damage to
unit, equipment,
and/or structure.
Hearing protection
Square
Wood shims
Tape measure
Sill pan flashing
2
S It is the responsibility of the builder, installer and
subcontractors to protect the interior and exterior of
windows or doors from excessive contact with harsh
chemical washes, construction material contamination and
moisture. Damage to glazing, hardware, weatherstrip and
cladding/wood can occur. Protect with painters tape and/or
protective sheathing as required. Follow all guidelines
regarding material use, preparation, personal safety and
disposal.
S Refer to the enclosed painting and staining instructions on
the last page for exterior and interior finish instructions.
S Contact your Marvin supplier if you have any questions
regarding product and materials used in manufacturing or
questions on replacement parts.
Help from another
to perform this task
safely and correctly. definitions, helpful
Standard Parts Shipped
Units are sent with hardware; clad units are sent with
four (4) nailing fin corner gaskets. Follow installation
instructions included with part if applicable. UDHM
units are sent with a fastening package and supple-
mental installation instructions.
NOTE: Depending on the installation method, other
material may be needed to properly prepare and seal
the installation such as self sealing adhesive mem-
brane, building paper, and seam seal tape, etc.
WARNING:
Wear the appropriate eye, ear and hand
protection, especially when working
with power tools.
3
Tips/Hints Impact Product
Information on Steps related to
alternative Impact rated
procedures, products only.
hints.
Always practice safety!
Window Installation
StormPlus and Structural Installations