Marvin Window User Manual page 14

Continuous Air Barrier Systems − Flashing the Installation
Figure 15: Sealing the installation in air barrier applications.
Window Flashing Detail (non−recessed masonry)
Figure 16: Flashing windows with casing in typical wood frame construction (non recessed masonry).
NOTE: Figure 16 shows a window with casing but the flashing detail also applies to any clad window product.
For installation in typical wood frame construction or brick veneer (non−recessed masonry openings), figure 16
shows the proper flashing detail in shingle style fashion. Once the exterior finish such as siding or brick veneer is
installed, a bead of sealant should be applied between the finish and the window/window casing along the sides and
approximately 1−2"
(25−51)
19970019
2012−04−10
Drip cap
Sealant
Window
casing/cladding
in from the ends at the head jamb (see insert). Use a backer rod when necessary.
1. Flash the installation in a weather board
fashion. For step by step instructions,
refer to
instructions
Opening Prep and Flashing Method
A1−Membrane Drainage System".
Head jamb
flashing
Sealant
Siding/
exterior finish
13
www.marvin.com/Roprep
titled "Window Rough
Seam
seal tape
Jamb
flashing
Window Installation
StormPlus and Structural Installations
for