Drawing Up The Bobbin Thread - Janome MC8200QC Instruction Book

z
q
w
x
e
c
r
v

Drawing up the Bobbin Thread

After using auto thread cutting or threading the bobbin
holder, you can start sewing without drawing up the
bobbin thread.
However, you need to draw up the bobbin thread when
sewing gathering stitches etc.
z Remove the bobbin. Insert the bobbin into the bobbin
holder again and rethread the bobbin holder according
to the instructions on page 20, but leave a 10 cm (4˝)
tail of bobbin thread as shown.
q Bobbin thread
NOTE:
Do not cut the bobbin thread with the thread cutter.
w Thread cutter
x Raise the presser foot. Hold the needle thread lightly
with your left hand.
e Needle thread
c Press the needle up/down button twice to lower and
raise the needle.
Pull the needle thread to bring up the loop of bobbin
thread.
r Needle up/down button
t
t Loop of bobbin thread
v Pull both threads 10 cm (4˝) under and behind the
presser foot.
23