Introduction To Jumper Settings And Other Connectors - AOpen EPC945-M8 Manual

Introduction to Jumper Settings and Other Connectors

JP14 Clear CMOS
You can clear CMOS to restore system default setting. To clear the CMOS,
follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
1
Normal
(default)
JP28 Keyboard/Mouse Wakeup Jumpers
You can use JP28 to enable or disable this function, which could resume your system from
suspend mode with keyboard or mouse. The factory default setting is "Disable" (1-2), and you
may enable this function by setting the jumper to 2-3.
Pin 1
1
Clear CMOS
Pin 1
37
1
Disable
Enable
(Default)
1