Introduction To Jumper Settings And Other Connectors - AOpen XC Cube TZ915 User Manual

Introduction to Jumper Settings and Other Connectors

JP14 Clear CMOS
You can clear CMOS to restore system default setting. To clear the CMOS, follow the
procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
1
Normal
(default)
JP28 Keyboard / Mouse Wakeup Jumper
You can use JP28 to enable or disable this function,
which could resume your system from suspend mode with
keyboard or mouse. The factory default setting is "Disable"
(1-2), and you may enable this function by setting the
jumper to 2-3.
1
Disable
(default)
40
TZ65II_915-OL-E0501A[49.BZ101.0A1].indd
1
Clear CMOS
1
Enable
40
Pin 1
Pin 1
2005/2/17, 下午 10:36