Janome Horizon MC8900 QCP Special Edition Instruction Book page 21

z
q
r
e
b
v
t
y
n
i
u
m
,
x
w
r
c
.
o
Winding the bobbin
NOTE:
Set the speed control slider at the fastest position.
z Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot.
q Guide slot
x Be sure that the thread is pulled down under the notch
and into the space below the guide slot as shown.
w Notch
c Draw the thread to the left and forward around the
thread guide.
Draw the thread to the rear and to the right around
and under the guide plate.
Firmly pull the thread to the right while holding it with
both hands.
e Thread guide
r Guide plate
v Put the bobbin on the bobbin winder spindle.
t Bobbin
y Bobbin winder spindle
b Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
n Insert the thread into one of the slits of the flange plate
and pull the thread to cut.
u Flange plate
i Slit
m Push the bobbin to the right. The bobbin winding
window appears.
, Start the machine. When the bobbin is fully wound, it
will stop spinning automatically.
Stop the machine and return the bobbin winder to its
original position by moving the spindle to the left.
. Remove the bobbin. Cut the thread with thread cutter.
o Thread cutter
NOTE:
For safety purposes, the machine will automatically
stop approximately 90 seconds after starting bobbin
winding.
19