Epson STYLUS PRO 7450 Unpacking & Setup Instructions page 24

Loading Cut Sheet Media with a Size
of A4, Letter or 8 × 10 Inches
To load cut sheet media with a size of A4, Letter
or 8 × 10 inches, follow the steps below.
c Caution:
As much as possible, keep your fingers off the
printable surface of the media, as fingerprints
may reduce printout quality.
1. Make sure that the printer is on and the roll
paper cover is closed.
2. Press the Paper Source l button repeatedly
until Sheet appears.
3. Make sure that the paper lever is in the
secured position, and then load the sheet into
the paper insertion slot until it meets
resistance. Make sure that the right edge of the
paper is straight and in line with the right edge
of the scale on the roll paper cover. PRESS
PAUSE BUTTON appears on the LCD panel.
4. Press the Pause button.
The print heads move and the sheet feeds into
the printing position automatically. READY
appears on the LCD panel.
Now the printer is ready to print. While the printer
is printing, do not open the front cover. If the front
cover is opened while printing is in progress, the
printer stops printing, and then restarts printing
when the front cover is closed. Stopping and
restarting printing may reduce the print quality.
When printing is complete, the printer supports
the printed media, and PAPER OUT. LOAD PAPER
is displayed on the LCD panel. To remove the
paper, press the Paper Feed button and then
release the paper lever while holding the paper.
The paper can be removed from the printer.
22
c
Caution:
Do not leave the paper in the printer for a long
period of time; its quality will deteriorate. We
recommend that you remove the paper from the
printer after printing.
Printing on Thick Paper (0.5 to
1.5 mm)
When you load thick cut sheets, such as
cardboard, follow the steps below.
Note:
❏ Do not load thick paper larger in size than B1
(728 × 1030 mm); otherwise, paper jams may
occur.
❏ Always load B1 (728 × 1030 mm) sized thick paper
long edge first. You may want to select the
Landscape setting in your printer driver.
1. Set the paper basket forward as described in
"Setting the Paper Basket" in the Paper
Handling section of the User's Guide.
2. Make sure that the printer is on.
3. Press the Paper Source l button repeatedly
until Sheet
appears.
4. Make sure that the Power light is not flashing,
and then set the paper lever to the released
position. LEVER RELEASED. LOAD PAPER
appears on the LCD panel.