Loading The Roll Paper - Epson STYLUS PRO 7450 Unpacking & Setup Instructions

Loading the Roll Paper

To load the roll paper onto the printer, follow the
instructions below.
1. Slide the movable flange off the end of the
spindle.
2. Place the roll paper on a flat surface so that it
unwinds in the direction shown. Slide the roll
paper onto the spindle and fully onto the fixed
flange.
3. Slide the movable flange back onto the spindle
until it fixes into place in the end of the roll
paper.
4. Open the roll paper cover. Holding the
spindle, fit the left and right ends of the
spindle into the mounting brackets inside the
printer.
Note:
The spindle and mounting brackets are
color-coded. Mount the spindle into the mounting
bracket that is the same color as the end of the
spindle.
5. Make sure that the printer is turned on.
6. Make sure that the Power light is not flashing,
and then set the paper lever to the released
position. The LEVER RELEASED. LOAD PAPER
appears on the LCD panel.
c Caution:
Do not set the paper lever to the released
position while the Power light is flashing.
Doing so may damage the printer.
7. Insert the paper into the paper insertion slot.
8. Pull the paper down through the paper
insertion slot so that it comes out below.
Note:
If the roll paper does not come out, follow the
instructions below.
19