Table of Contents
Advertisement
Assembling the StretchTrainer
Assembling the StretchTrainer
CAUTION: At least two people are required to position the parts
of this equipment successfully. Do not attempt to assemble the
equipment by yourself. Fully assembled, the StretchTrainer
weighs over 60 pounds.
Proper alignment and adjustment of the equipment is critical.
When you install fasteners, leave room for adjustments. Do not
tighten the fasteners completely until you are instructed to do so.
Make sure the equipment is stable and placed on a solid surface.
Optional tools:
To begin assembly:
1.
2. While your assistant holds the upright supports, slide the
Open-end adjustable wrench
Pair of needle-nose pliers
Set the base rails on the floor and remove the two bolts
and two flat washers on the underside of the rails.
seat bracket under the base rails and align the mounting
holes. Place the alignment bracket in between the base
rails and secure it using the two 5-inch bolts, four flat
washers, and two locknuts from the hardware kit.
Figure 3: Alignment bracket and base rail assembly
11
Hide quick links:
Advertisement
Table of Contents
