Confirming The System Construction - Sony VPL-X2000E Operating Instructions Manual

Connection Examples

Confirming the System Construction

When a system error is detected
44
(GB)
After all the connections are complete, confirm that equipment of the
system is properly setup.
1
Connect the AC cords of all equipment to the AC outlets.
2
Press the SYS SET key on the Remote Commander.
You can also press the LIGHT and RESET keys simultaneously on the
control panel for the same effect.
Information on the system construction and the settings of the interface
boards, etc. are automatically confirmed. Then the message disappears.
Note
When you want to use the projector without connecting the switcher after
using the switcher in the system connections, it is necessary to confirm the
system construction again by pressing the SYS SET key or the LIGHT and
RESET keys after all the connections are complete. If you press the key(s),
"Master Switcher not exist" appears, but the system construction is
automatically recognized.
The following messages are displayed on the screen and display window:
Message
Master Switcher not exist.
Same DEVICE INDEX for Projector
detected.
Same DEVICE INDEX for Switcher
detected.
Note
If the switcher is in standby mode, the message appears only in the
message display window.
Remedy
Set the switcher that outputs the signal to
the projector to number 1.
Change either number of the projectors
that have the same number.
Change either number of the switchers
that have the same number.