Chevrolet 2006 HHR Owner's Manual page 91

If the remote start procedure is used again before
the first 10 minute time frame has ended, the
first 10 minutes will immediately expire and the
second 10 minute time frame will start.
After two remote starts have been provided, the
vehicle's ignition switch must be turned to RUN
and then back to LOCK using the key, before the
remote start procedure can be used again.
If you enter the vehicle after a remote start, and the
engine is running, insert the key into the ignition switch
and turn it to the RUN position to drive the vehicle.
To manually shut off the engine after a remote start,
do any of the following:
•
Aim the remote keyless entry transmitter at the
vehicle and press the remote start button until
the parking lamps turn off.
•
Turn on the hazard warning flashers. See Hazard
Warning Flashers on page 3-6.
•
Insert the vehicle's key into the ignition switch and
turn the switch to RUN and then back to LOCK.
The remote vehicle start feature will not operate if:
•
The remote start system is disabled through
the DIC.
•
The vehicle's key is in the ignition.
•
The vehicle's hood is open
•
The hazard warning flashers are on.
•
There is an emission control system malfunction.
See Malfunction Indicator Lamp on page 3-35.
•
The engine coolant temperature is too high.
•
The oil pressure is low.
•
Two remote vehicle starts have already been
provided.
2-9