Preset Tuning - Sony STR-DE675 Operating Instructions Manual

Preset Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 39.
Before tuning to preset stations, be sure to preset them by
performing steps on "Presetting radio stations" below.
Presetting radio stations
1
Press TUNER.
The last received station is tuned in.
2
Tune in the station that you want to preset using
Direct Tuning‚ or Automatic Tuning (page 40).
3
Press MEMORY.
"MEMORY" appears in the display for a few seconds.
Do Steps 4 to 6 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A," "B" or "C"
appears in the display.
5
Select a preset number by pressing PRESET
TUNING + or PRESET TUNING –.
If "MEMORY" goes out before you press the preset
number, start again from Step 3.
6
Press MEMORY again to store the station.
If "MEMORY" goes out before you can store the
station, start again from Step 3.
7
Repeat Steps 2 to 6 to preset another station.
To change a preset number to another station
Do Steps 1 to 6 to preset the new station to the number.
Note
If the AC power cord is disconnected for about one week, all the
preset stations will be cleared from the receiver 's memory, and
you will have to preset the stations again.
Tuning to preset stations
You can tune the preset stations either of the following
two ways.
Scanning the preset stations
1
Press TUNER.
The last received station is tuned in.
2
Press PRESET TUNING + or PRESET TUNING –
repeatedly to select the preset station you want.
Each time you press the button, the receiver tunes in
one preset station at a time, in the corresponding order
and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
1
Press TUNER.
The last received station is tuned in.
2
Press SHIFT to select a memory page (A, B or C),
then press the preset number of the station you
want using the numeric buttons on the supplied
remote.
41