Replacing The Fuse; Replacing The Battery; Adjusting The Self-Propel Drive - Toro TimeMaster 20975 Operator's Manual

Replacing the Fuse

Electric-start model only
If the battery does not charge or the engine does not turn
with the electric starter, the fuse may be blown; replace it with
a 40-amp plug-in type fuse.
Important: You cannot start the machine with the
electric starter or charge the battery unless a working
fuse is installed.
1. Open the sealed fuse holder and replace the fuse
(Figure 37).
1
1. Fuse holder
2. Close the cover to the fuse holder, and ensure that it
is sealed tightly.

Replacing the Battery

Electric-start model only
Contact an Authorized Service Dealer.
g016487
Figure 37

Adjusting the Self-Propel Drive

Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive.
1. Turn the adjustment knob counterclockwise to loosen
the cable adjustment (Figure 38).
1. Handle (left side)
2. Adjustment knob
3. Self-propel-drive cable
2. Adjust the tension on the cable (Figure 38) by pulling it
back or pushing it forward and holding that position.
Note: Push the cable toward the engine to increase
the traction; pull the cable away from the engine to
decrease the traction.
3. Turn the adjustment knob clockwise to tighten the
adjustment of the cable.
Note: Tighten the knob firmly by hand.
20
Figure 38
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.