Husqvarna 305 Operator's Manual page 67

305_308,EN.book Page 67 Saturday, November 8, 2014 12:33 PM
Message
Trapped
Outside working area
Low battery
Wrong PIN
Right wheel
overloaded
Left wheel overloaded
9. TROUBLESHOOTING
Cause
The robotic lawnmower has got
caught in something.
The robotic lawnmower is stuck
behind a number of obstacles.
The boundary wire connections to the
charging station are crossed.
The boundary wire is too close to the
edge of the working area.
The working area slopes too much.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects
(fences, reinforcement steel) or
buried cables close by.
The robotic lawnmower finds it hard
to distinguish the signal from another
robotic lawnmower installation close
by.
The robotic lawnmower cannot find
the charging station.
The guide wire is broken or not
connected.
The battery is spent.
The charging station's antenna is
defective.
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five
minutes.
The robotic lawnmower has got
caught in something.
Action
Free the robotic lawnmower and
rectify the reason for it becoming
trapped.
Check if there are any obstacles
which make it hard for the robotic
lawnmower to move on from this
location.
Check that the boundary wire is
connected correctly.
Check that the boundary wire has
been laid according to the instructions
in chapter 3. Installation.
Check that the boundary wire has
been laid according to the instructions
in chapter 3. Installation.
Check that the boundary wire has
been laid according to the instructions
in chapter 3. Installation.
Try moving the boundary wire.
Place the robotic lawnmower in the
charging station and generate a new
loop signal via Security -> New loop
signal.
Check that the charging station and
the guide wire are installed in
accordance with the instructions, see
3. Installation on page 18.
Check that the indicator lamp in the
charging station flashes yellow. See
the solution in 9.2 Indicator lamp in
the charging station on page 69.
Replace the battery. See 8.8 Battery
on page 65.
Check if the indicator lamp in the
charging station flashes red. See the
solution in 9.2 Indicator lamp in the
charging station on page 69.
Enter the correct PIN code. Contact
the local dealer if you forget the PIN
code.
Free the mower and rectify the
reason for the lack of drive. If it is due
to wet grass, wait until the lawn has
dried before using the mower.
English - 67